Packaging Disposal; Transportation And Handling - OEM TL45 Gebrauchsanweisung Und Warnhinweise

5.2.1. Packaging removal
To remove the packaging, follow these steps as described :
ACTION
STEP
Place the machine in the place intended for it.
1
Unpack the parts delivered on pallets, as follows:
Remove the strapping;
•
2
remove the carton;
•
remove cellophane;
•
remove any fixing systems to the wooden floor.
•
IMPORTANT!
Follow the table in paragraph "Group and Weight Division Table" to see which and how many
separate parts the machine will be transported.
For the machine handling, refer to section "Transport".

5.2.2. Packaging disposal

The packaging is an integral part of the supply and is not collected, so the disposal is in charge to the buyer.
Any disposal or destruction must take place in accordance with the regulations in the user's country, considering the
nature of the materials:
wooden for boxes;
•
Plastic film for the protection of the oven and adhesive tapes for fixing them;
•
bags of absorbent substance for dampness.
•
Etc.
•

5.3. Transportation and handling

The OEM ALI GROUP S.R.L A UNICO SOCIO, considering the ways of transport, uses appropriate packaging and
fixtures to ensure integrity and storage during transport.
When receiving the machine, verify that no party has been damaged during transport and/or handling.
If damage is found, it is mandatory to report them immediately to the Manufacturer.
The handling activities described in this section must be carried out by qualified personnel for such operations:
specially trained personnel to carry out loading, unloading and handling operations by means of lifting.
ATTENTION!
The OEM ALI GROUP S.R.L A SOCIO UNICO
people, caused by accidents caused by non-compliance with the instructions in this manual.
Page 118
EC-compliant use and warning instructions
accountable for the damages, to property or to
is not
CHAPTER 5 – TRANSPORT AND INSTALLATION