Connection To Power Socket; Using The Product; Standby / On; Select Modes - Silvercrest SBS 60 B2 Bedienungs- Und Sicherheitshinweise

˜ Connection to power socket
Attention! Risk of product damage!
Ensure that the power supply voltage
corresponds to the voltage printed on the
back of the product .
Connect the AC power cord to the power
socket on the product and a wall outlet .
12
Notes:
Ensure all connections are connected before
connecting to the mains power socket .
Be sure to unplug the power cord from the
outlet when the system is not in use for an
extended period of time .
˜ Using the product
˜ Standby / ON
After connecting the soundbase to a wall
outlet, switch the product on using the I/O
switch . The soundbase is in standby mode
11
now, as indicated by the red LED display .
Press the button
device or on the remote control to switch the
main unit ON .
Press the button
the product back to standby mode . The LED
display lights up red .
14 GB
/ on the main
1 18
/ again to switch
1 18
Disconnect the mains plug from the wall
socket or switch the I/O switch
rear of the product to switch the product off
completely .
Note:
When turning the product on again, it will
continue with the same mode that was used
prior to turning off the product last time .
If the product is idle for over 15 minutes, the
product will automatically switch to Standby
mode .
˜ Select modes
Press the button
2
or press the AUX1, AUX2, BT (Bluetooth
OPTICAL, COAXIAL, HDMI ARC, USB buttons on
the remote control to select the desired mode .
Indicator
1 Red
2 Orange / flash
3 Blue
4 Orange / flash
5 Orange / flash
on the
11
repeatedly on the product
),
®
Mode
Standby
AUX1 / AUX2
BLUETOOTH
®
OPTICAL /
COAXIAL
HDMI ARC / USB