Crane Transport - Pfannenberg DTS Serie Betriebsanleitung

ENG
4.2.2

Crane transport

DANGER
Danger of death from suspended loads
Tipping or falling loads can cause severe to fatal injuries.
• Never stand beneath suspended loads.
• Only use approved lifting gear and slings which are designed for the total weight of the attached load.
• Only use slings/load handling devices in technically perfect condition.
• Observe the sling points and center of gravity of the load.
• Secure loads with suitable devices.
WARNING
Risk of injury due to improper crane transport
Moving switch cabinets with integrated cooling units can lead to accidents.
• Lifting by M6 jack rings is only permitted for the cooling unit.
• Ensure that jack rings and unit threads are not damaged or deformed.
• Only use jack rings with a sufficient thread length according to DIN 580 and check that they are securely fitted.
Fig. 9: M8 jack rings DTI/DTS cooling units
1 M8 jack rings
The cooling units have screw-in threads for M8 jack rings. Cooling units with bolted M8 jack rings may be used for crane
transport.
Requirements
• The unit has been completely unpacked.
• Observe the minimum screw-in depth of the M8 jack rings according to DIN 508.
• The M6 jack rings and cooling unit threads are free of damage (corrosion, deformation).
• The fastening screws (2×) were removed from the unit cover.
Procedure
1. Screw in the M8 jack rings (2×) completely.
2. Check that the M6 jack rings are securely fitted in the cooling unit as prescribed.
 The M8 jack rings are screwed in the cooling unit and the unit can be moved.
Operating Manual | Attachment and Installation Cooling Units | Multi Controller (MC) – 230 V | 086100000e
2 Unit cover fastening screws
G00006
27/66