Chapter Iv Operating Instructions; Operation Interface - SAT AE2021 Bedienungsanleitung

Chapter IV Operating Instructions

4.1 Operation interface

内侧轮辋
14
1. Distance enter key
2. Width enter key
3. Diameter enter key
4. Emergency stop key
5. Start key
6. Display actual unbalance value (less than 5g)
7. Recalculation key
8. Dynamic and static mode switch key
9. Balance mode selection function key
10. Select "optimization"
11. Display the balance mode
12. Display the outer unbalance position on
outer
13. Display the inner unbalance position
14. Display the inner unbalance value
15. Display the outer unbalance value
Note
Press the keys with hands. To press the keys with balance plier or other sharp objects is not allowed.
AE2021
外侧轮辋
13 12 15
Function of main combination keys:
- Press [C] +[F] key, and then press [START] key for self-calibration only when the light
stops flashing.
- In state of unbalance value display, Press [F]+[A-] key to convert from unbalance value
in g to that in oz.
- When [b] key is pressed, press [F]+[W+]or［[W-] key to convert from rim width in mm
to that in inch.
- When [d] key is pressed, press [F]+[D+]or［[D-] keys to convert from rim diagram in
mm to that in inch, and then press [OPT] key to optimize the unbalance value.
- Press [F]+[STOP] key to switch from start to cancel of instant startup function of
protective cover.
Note:
1. The instant startup function of protective cover can be maintained after shutdown.
2. The function of selecting inch as the unit of rim width and rim diagram cannot be
maintained after shutdown.
中文
5 4
11 9
EN DE RU KO PT
1 2
10 6 7
JA ES
3
8
43