Commissioning And Operation; Installation Guidelines; Air Hose Connection - HEYLO PF1000 Betriebsanleitung

h) Make sure the device is securely fastened in
place, cannot move and will not tip over either in
operation or otherwise.
 The device is then set up and installed. Air hos-
ing can be attached to the air intake and outlet
(see theAccessories list
16 Commissioning and
operation
WARNING
Risk of injury if operated without filters
The device may suck in particles from the surround-
ing air and disseminate same if not equipped with
filters.
a) The device may only be operated with filters.
Commissioning
a) Make sure that the device is not standing on a
wet surface, is standing upright and is securely
fastened in place.
Switch the device on
a) Turn the device ON / OFF switch ON.
 The continuous operating mode will start and
the unit will run until turned off using this
switch.
 The device is now switched on.
Switching the device off
a) Turn said switch off.
 The device is now switched off.
After operation
The device must be thoroughly cleaned after every
use before being removed from the area in which it
operated (see Device servicing, maintenance and
cleaning [ 42]).
EN
[ 47]).
The device can be sealed with closing covers before
being removed from its area of operation to prevent
contamination dissemination (see the optional
Zubehör [ 47]).
Safety measures when moving the device
If the device site is changed then the preliminary
(first stage) filter/s should be replaced beforehand.
Transport may be in a separate airtight container or
garbage sack.
See also
 Safety [ 30]
16.1

Installation guidelines

All applicable local rules must be complied with in in-
stalling and using this device. In Germany this inclu-
des those below.
– Workplace Ordinance - ArbStättV
– Workplace Guidelines ASR
– DGUV (occupational health and safety) rules
– Accident prevention regulations VBG 43
– German Ordinance on Hazardous Substances
– BGR 128 (employers' liability insurance)
(available from: DIN Software GmbH).
HEYLO cannot accept any liability whatsoever for
any and all damage arising from improper use
and/or installation of the device.
16.2

Air hose connection

The device is equipped with connections to which air
hoses can be attached at the air intake and outlet
ends.
Procedure
a) Switch off the device before starting work and
pull out the mains plug.
b) Slide the air hose over the attachment fitting.
Air cleaner PF1000
39 / 50