Instructions For Operation; Operating Conditions - HEYLO PF1000 Betriebsanleitung

– Always ensure that the device switch is in the
OFF position before inserting the mains plug in
the mains socket.
– The device may only be moved when switched
off.

Instructions for operation

During operation and troubleshooting:
– Only a trained operator may work on the device.
– Children must be kept well away from the de-
vice.
– Do not modify, dismantle or take any safety de-
vices out of operation. The safety devices must
be inspected at regular intervals.
– All the covering panels, covers and hoods must
be installed as intended.
– Structural changes to the device are not allowed.
– The device must not be used in rooms with ex-
plosive atmospheres.
– Always wear the prescribed personal protective
equipment when operating the device.
– All applicable legal and employers' liability insur-
ance rules must be adhered to when disposing
of hazardous material. The device operator is
wholly and solely responsible for obtaining any
and all information needed to safely handle, and
deal with, hazardous material. If necessary said
operator must draft a risk evaluation before han-
dling, or dealing with, hazardous material.
Maintenance and troubleshooting
instructions
The following apply to maintenance and trouble-
shooting:
– Only suitably qualified staff may perform this
work on the device.
– The device must be switched off and the mains
plug pulled out of its mains socket.
EN
13.1

Operating conditions

Under inadmissible operating conditions, the opera-
tional safety and the performance of the device may
not be sufficiently ensured. Inadmissible operating
conditions must therefore be avoided at all times.
The device must not be used in rooms with explo-
sive atmospheres.
The device is intended for mobile or stationary use
indoors, on construction sites and in garages and
storage spaces / rooms. The air temperature in the
device may not exceed 60 °C.
Only original spare parts or parts approved by the
manufacturer may be used.
The following conditions and safety rules must al-
ways be adhered to.
– Always handle the device with care. Never drop
the device, throw it or transport it in any vehicle
without securing it properly.
– The device must be installed upright and stable.
It must not fall over or slip even under full load.
– Do not cover the device during operation.
– The device must not be operated in puddles or in
stagnant water. If the device or the connection
cable gets wet then it must be dried thoroughly
before the device may be operated.
– Make sure that the device does not suck in any
oil, grease or other contaminant.
– The mains voltage must correspond to the de-
tails on the rating plate.
– Extension cables must be selected according to
the performance data on the rating plate, in or-
der to prevent overload.
– The socket used must be earthed or protected
with a current operated earth leakage circuit
breaker when installed indoors.
People under the influence of alcohol, drugs or med-
ication must not operate or maintain the device.
Air cleaner PF1000
31 / 50