HEYLO PF1000 Betriebsanleitung Seite 37

rate of 15. The device must be operated at 100% ca-
pacity to guarantee maximum performance and a
correct display of filter status. If air intake and outlet
hoses are used then hosing must be coupled to both
connections (hose diameter of 205 mm - for acces-
sories see Accessories list
Recirculating air mode
The device is to be installed in the middle of the
space / room of which the air is to be cleaned. The
airborne particles generated by the device in opera-
tion are ingested thanks to the constant change of
air and captured by the filtration equipment therein.
A hose should be connected to the intake or outlet
end in such a manner as to ensure that ventilation of
the entire room / premises concerned is ensured.
Fig. 9:
Recirculating air mode
Vacuuming where originated
Particles are to be vacuumed as close as possible to
where they are generated. Tools running at high
speed should always be operated with vacuuming.
The device can be equipped with air hosing to vac-
uum all further dust. This should be as close as pos-
sible to wherever the dust arises. This minimises the
spreading of airborne dust in the room / space via
room / space air.
EN
[ 47]).
Means of securing hosing are available as accesso-
ries (see Accessories list
Maintaining vacuum
The area in which the air is to be cleaned must be
isolated. This can be done using dust protection
walls or foil doors. Said area should be as small as
possible. Filtered exhaust air can be vented into the
open air using air hosing. The device can be in-
stalled either inside or outside the room / space in
which the air is to be cleaned. Run the device in vac-
uum mode throughout the period during which work
is performed in the room / space concerned.
Fig. 10:
Maintaining vacuum
Air cleaner PF1000
[ 47]).
35 / 50