Putting Into Operation / Operation - HEYLO PF 1400 Bedienungsanleitung

Extension cable: Use approved extension cables only !
Handle with care: Do not drop or throw the unit as this may cause damage to the unit or wiring.
Operate on solid surface: Always set up the unit on a solid and plane surface.
Secure during transport: When transporting devices in vehicles, secure against slipping.
Keep dry: The unit must not be operated in puddles or in standing water. Do not store or operate
outdoors. If the electric wires or parts of the unit get wet, the unit has to be thoroughly dried before re-
using.
Keep the air openings free: Do not cover or block the air inlets and outlets.
Disposal: If the unit has been used in polluted air, pack the used filter in air-tight sacks and dispose of
them professionally. The change of filter has to be carried out wearing breathing protection.
Environment: Do not use in explosive areas.

(4) Putting into operation / operation

1. Switching the unit on: To switch the unit on, the main switch (A) has to be turned to the right
(then the switch is lit yellow).
2. Power control: The power regulator (B) can be set to an air flow rate of between 0 and 100
per cent. It is recommended to operate the unit at 100 per cent.
ATTENTION: After switching the unit on, it will take about 10 s to start up the fan motor.
This is no fault !
3. Change of filter indicator: When the main filter is saturated, this will be indicated by display
(C). When this signal is released, the main filter as well as the pre-filter has to be replaced. Please
remember to have sufficient filter material available.
The service life of the filter depends on the quantity of dust drawn in. An integrated differential
pressure switch is used to determine the air flow through the filter.
4. Energy metre: The energy metre (D) can be used to read off the power consumption in kW/h,
which, if and when necessary, is included in the documentation or used for billing with the
insurances.
C
D
15
B A
EN