Balluff BIS U-6028-048-104-06-ST28 Betriebsanleitung Seite 61

BIS U-6028-048-1_4-06-ST28
Processor unit
7
Setting the processor unit parameters (continued)
Device settings
Carrier follow-up time
For hardware version 2.0 or higher, the Carrier
follow-up time function no longer exists. The
value does not have any effect.
Follow-up time in seconds of the switched-on antennas
after the command is sent. The read or write command
should be executed within this time after detection.
Factory setting: 5 seconds
Max. number of tags at the same time
Maximum number of expected data carriers in the field.
Factory setting: 128
Ambient
Factor rereadings (only for asynchronous detection or
dynamic mode)
Number of rereadings after which a data carrier is reported
as present (tag coming) or number of failed rereadings
after which a data carrier is reported as not present (tag
going) (only in dynamic mode).
Factory setting: 5
www.balluff.com
ETSI channels
The channel setting determines the channel assignment. If
multiple channels are activated, the device automatically
selects them by means of the frequency hopping method.
Factory setting: channel 4 switched on, channels 7...13
switched off
The ETSI channel selection is only available
when using the devices within the European
Union.
Transmitting power
The Gain and Loss parameters are defined in
the Antenna type and Cable type fields. These
values are used to determine the maximum
permissible radiated power.
The maximum permissible radiated power and
factory settings differ depending on the set
country profile. For information on the valid
regulations of the different countries, see
chapter Safety on page 6.
In the countries of the European Union, the
radiated power is specified in the form of ERP
(max. 2 watts ).
ERP
In the USA, Canada, Brazil, the radiated power
is specified in the form of an EIRP power (max.
4 watts ).
EIRP
See the "Basic UHF manual" for more
information on radiated powers.
english 17