Resetting The Min/Max Value; Resetting The Totalizer; Display Hold - Phoenix Contact MCR-FL-D-U-I-2SP-24 Bedienungsanleitung

6.2 Setting the Alarms during Operation
When an alarm value is shown in the dis-
play, its set value can be changed.
Alarm 1 is displayed. LED 'Pr1' is
illuminated
Set Alarm
Display Action
Select digit position and
set digit.
Example: 300.0
press the key to accept and go to Alarm 2
Alarm 2 is displayed. LED 'Pr2' is illuminated
Set Alarm
Display Action
Select digit position and
set digit.
Example 800.0
press the key to accept the selection
6.3 Resetting MIN/MAX value
Resetting is only possible if this has been
enabled in the parameter mode.
Page 30
Note: the "key-lock" should not
be enabled.
Select Min/Max value display
• press the red key.
• the stored value is cleared

6.4 Resetting the Totalizer

Resetting is possible only if the MP input
has been programmed for the Reset
function.
Depending on the setting, the resetting is
carried out either manually with the red
key, and /or electrically with a high pulse
( > 4V; > 5 ms)at the reset input.

6.5 Display Hold

The Display Hold function is only available
for use with the current measured value
and for the totalizer value.
For as long as a high level signal
( > 4 V DC ) is present at the MP input,
The Display Hold function is only active with
the following parameter settings:
Parameter
Reset totalizer value
And
Alarms
Reset totalizer value
And
Alarms
Output Mode
Reset totalaizer value
And
Alarms
Output Mode
Reset-Alarm-Latch
Reset:
• Ensure the totalizer value is shown in the
display
• Press the red key and/or apply a high-
level pulse at the MP input
• The value in the totalizer will be cleared
then the display is "frozen".
The MIN/MAX capture, alarm monitoring
and totalizer functions continue in the
background.
Settings
or
/
or
/
/
or
/
/
/
Page 31