Mains Hum Filter; Setting Default Value; End Of Setup; Check/Alter Parameters - Phoenix Contact MCR-FL-D-U-I-2SP-24 Bedienungsanleitung

5.6.2.1 Reset Minimum value
Menu <–> Selection
Example: Yes
not resettable
resettable via the
The MIN value can only be cleared by pressing the red key. In addition "MIN"
press the key
must be selected as the display source. In parameter set-up "r.MIN" must be
programmed as "YES"
to accept
5.6.3 Effects resulting from exceeding the measuring range limits or of
Overload/Underload on MIN/MAX.
If the signal measured lies outside the
measuring range limits or
then the current measured
value will be recorded either as a MIN
value or as a MAX
value . If the signal is in an

5.7 Mains Hum Filter

To reduce the interference from mains line and the environment (mains hum), the instru-
ment must be set to the local mains frequency.
Menu <–> Selection
Local power line 60 Hz
Local power line 50 Hz
press the key to accept the selection
Page 26
key .
overload or underload condition, then it
will be saved either as as a MIN value
or as a MAX value
. .
5.8 Setting Default Values
The user has the possibility to set all pa-
rameters back to their default values by
using the parameter . This pa-
rameter must be programmed
with the value =07049 If you
then proceed to the next parameter using
Menu <–> Selection
Select digit
Set digit 07049
press the key to accept the selection
5.9 End of Setup Yes/No?
Menu <–> Selection
Parameters will be stored -> Operation

Check/alter Parameters

press the key to accept the selection
the keys, then all parameters are reset to
their default values. It is not necessary to
finish the programming; a new program-
ming cycle can take place immediately.
➱
Chapter 5.11, 28
Page 27