Troubleshooting - ECOVACS ROBOTICS WINBOT X Bedienungsanleitung

No. Malfunction
When Safety Pod is powered ON,
1 WINBOT reports "Please turn on
Safety Pod."
After Safety Pod is powered ON,
2 the Battery Indicator makes no
react.
When WINBOT is working or
paused, the Safety Pod Status
3 Indicator on WINBOT flashes RED
and WINBOT reports "Insufficient
suction power."
When WINBOT is working or
paused, the Safety Pod Status
4 Indicator on WINBOT flashes RED
and WINBOT reports "Safety pod
signal error."
When WINBOT is working or
paused, the Safety Pod Status
5 Indicator on WINBOT flashes RED
and WINBOT reports "Safety pod
not plugged in correctly."
6 The Remote Control does not work.
Possible Causes
Safety Pod is in Sleep
Power ON Safety Pod again to wake it up.
Mode.
Safety Pod's batteries are Replace the batteries as indicated in Section 3 Maintenance. If the
low. problem persists, please contact customer care.
Detach Safety Pod from the window, clean Safety Pod with a clean
Safety Pod is losing
cloth and attach it to the window again until the Safety Pod Status
suction.
Indicator on WINBOT glows GREEN.
Within 60 seconds after powering ON WINBOT, press and hold
Safety Pod is not paired
WINBOT START/PAUSE Button and the Safety Pod Pairing Button at
with WINBOT or has a
the same time until the Safety Pod Status Indicator flashes GREEN and
pairing malfunction.
RED indicating the pairing is successful.
The Safety Pod Connector
is not properly connected Insert the Safety Pod Connector into the Safety Pod port, press it and
to the Safety Pod Port on turn clockwise until it locks into place.
WINBOT.
Switch OFF and restart the robot. Within 60 seconds, press and
Remote Control is not
hold
paired with WINBOT or
until the indicator flashes GREEN and RED indicating the pairing is
the pairing is invalidated.
complete.

5. Troubleshooting

Solutions
on WINBOT and on the Remote Control at the same time
23
EN