Programming And Deleting The Run Times - Becker MC611 Montage- Und Betriebsanleitung

Programming and deleting the run
This receiver can save a switching time for one
ively. The drive command saved in this way is executed automatically every 24
hours when the Memo function is activated. Previously programmed run times
are overwritten.
Programming the run times
6s
or
6s
70 - en
times
The tubular drive must be in the upper limit posi-
tion to program the
limit position to program the
Wait until the time at which the automatic drive
command is to be carried out.
At the desired time, press and hold the relevant
travel button until the tubular drive briefly stops
after approx. 6 seconds then continues to the limit
position.
Now release the direction button.
► The receiver has saved the current time for
this direction of travel. Proceed in exactly the
same way with the other direction of move-
ment. No automatic drive commands are ex-
ecuted in the operating mode " ". The saved
run times are retained.
and one cycle respect-
run time, and in the lower
run time.