Changing The Direction Of Rotation Of B-Tronic Products - Becker MC611 Montage- Und Betriebsanleitung

Deleting a B-Tronic transmitter from a KNX RF
compatible receiver from another manufacturer
Please find the appropriate description in the instructions for the receiver.
Changing the direction of rotation of B-Tronic
products
Check the direction of rotation before setting the limit positions. The shading
solution must move in the correct direction when the UP or DOWN buttons are
pressed.
If this is not the case, please carry out the following steps to change the direc-
tion of rotation:
No limit positions must be programmed. Delete the limit positions if neces-
sary.
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
3s
58 - en
button until the desired receiver con-
First press the programming button and, within
the next 3 seconds, press both the UP and DOWN
buttons for 3 seconds.
▻ The receiver confirms.
Check the running direction again.