Commissioning Of B-Tronic; Knx Rf S-Mode; Normal/Master Mode - Becker MC611 Montage- Und Betriebsanleitung

Commissioning of B-Tronic

Explanation of symbols
0

KNX RF S-Mode

When used as KNX RF S-Mode device, the function switch must be perman-
ently set to position 6. If this is turned to a different position, the device will no
longer work as programmed. As soon as the function switch is turned back to
position 6, the function as programmed will once again be available.

Normal/master mode

The transmitter can be operated in two modes:
• Normal mode (normal operation) The commands that are issued apply
to all the receivers of a channel.
• Master mode (Setting mode for all B‑Tronic products). The commands
issued apply exclusively to one selected receiver of a channel.
The normal mode is set at the factory.
Up/retract button
STOP button
Down/extend button
Programming button (on the transmitter
Master button (on transmitter
Function switch (on transmitter
Receiver confirms once or multiple times by
"clicking" or "shifting"
)
)
0
)
53 - en