Performing The Programming Run On B-Tronic Radio Receivers - Becker MC611 Montage- Und Betriebsanleitung

Performing the programming run on B-Tronic
radio receivers
Feedback is disabled and it is not possible to program the in-
termediate positions until the programming run has been
performed.
Put the transmitter into master mode.
Select the receiver by pressing the
firms.
All the following settings will then only be executed for this device.
64 - en
button until the required receiver con-
Open to the desired upper limit position.
Press the programming button and, within 1
second, also press the UP button and hold the two
buttons down.
▻ The receiver confirms.
Then close to the desired lower limit position.
Press the programming button and, within 1
second, also press the DOWN button and hold the
two buttons down.
▻ The receiver confirms.
► The programming run is completed.