Troubleshooting - JUNO JGVX605E1 Benutzerinformation

1. Move the upper basket to the lowest
level to reach the spray arm more
easily.
2. To detach the spray arm (C) from the
delivery tube (A), turn the mounting
element (B) counterclockwise and pull
the spray arm downwards.
3. Wash the spray arm under running
water. Use a thin pointed tool, e.g. a
toothpick, to remove particles of soil
from the holes. Run the water through

TROUBLESHOOTING

WARNING! Improper repair of
the appliance may pose a
danger to the safety of the
user. Any repairs must be
performed by qualified
personnel.
The majority of problems that may
occur can be solved without the need
Problem and alarm code
You cannot activate the ap‐
pliance.
The programme does not
start.
the holes to wash soil particles away
from the inside.
C
B
A
4. To install the spray arm (C) back,
insert the mounting element (B) in the
spray arm and fix it in the delivery tube
(A) by turning it clockwise. Make sure
that the mounting element locks into
place.
to contact an Authorised Service
Centre.
Refer to the below table for information on
possible problems.
With some problems, the lights related to
the programme buttons flash intermittently
to indicate a malfunction and the alarm
code.
Possible cause and solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance recharges the resin inside the water soften‐
er. The duration of the procedure is approximately 5 mi‐
nutes.
21