Operation; Power Supply; Switching On/Off; Switching On The Unit - Bosch BEA 070 Originalbetriebsanleitung

4.

Operation

!
Transport the BEA 070 only in an upright position
via the carrying handle. Select the installation lo-
cation such that the BEA 070 cannot fall and is al-
ways correctly positioned (carrying handle at top).
4.1

Power supply

The power supply is obtained from the lighting system.
The BEA 070 can operate at between 100 V and 240 V,
50/60 Hz.
!
Prior to start-up, make sure the lighting system vol-
tage coincides with the set voltage of the BEA 070.
If the BEA 070 is operated outdoors, it is advisable
to use a voltage source protected by a residual
current-operated circuit breaker. Only operate the
unit in dry conditions!
!
To avoid the formation of condensation, allow the
BEA 070 to adjust to ambient temperature before
switching it on.
i
The details of the power supply are provided on
a sticker on the back of the BEA 070.
4.2

Switching on/off

4.2.1

Switching on the unit

1. Plug the power cord into the BEA 070, and attach
to the holes (Fig. 1, Pos. 4) with a cable tie to pro-
vide strain relief.
2. Connect the BEA 070 to the lighting system via the
power cord.
3. Press the On/Off button.
"
The LED flashes alternately orange and green (Fig.
1, Pos. 12).
4.2.2

Switching off the unit

i
First exit from the exhaust gas test step, and wait
for the fan to stop running. Only then, switch off
the BEA 070.
¶
Press the On/Off button for more than two seconds.
"
LED is not lit, the BEA 070 is off.
Robert Bosch GmbH
Operation | BEA 070 | 21 |
4.3 Connecting the BEA 070 in
stand-alone mode
The following description for installing the BEA-PC
system software and the AU vehicle data and configu-
ring the BEA 070 only applies if the BEA 070 is to run
in stand-alone mode.
4.3.1

Installing the BEA-PC software

i
Pay attention to the system requirements before
starting installation.
i
Only plug in the Bluetooth USB adapter when
prompted to do so during software installation.
1. Close all open applications.
2. Insert the "SystemSoft BEA-PC" DVD in the DVD
drive.
3. Start "Windows Explorer".
4. Start 'D:\RBSETUP.EXE' (D = DVD drive letter).
 Setup starts.
5. Confirm with <Continue>.
6. Follow the instructions on the screen.
7. Reboot the PC/laptop to successfully conclude
installation.
"
BEA is installed.
en
|
1 689 989 113 2020-06-24