Application Settings; Network Settings Las - OSRAM e:cue Lighting Control Engine 3 Bedienungsanleitung

Configuration
— In the pop up window
— Enter or select the IP address(es) of your network at
for e:net
—
Click
OK
the network settings for SYMPHOLIGHT are now configured.
Notice that only the network settings for the SYMPHOLIGHT
application have been set now. If you have further network devices
installed, each of these devices have to be configured separately.
See the SYMPHOLIGHT Setup Manual for details. Without a DHCP
server, attach only one SYMPL node at a time; otherwise, identical
IP addresses will conflict and disturb proper communication.
6.5

Network Settings LAS

The e:cue LAS is pre-installed on the LCE 3 (fx). The LAS is a
software for creating light shows and controlling complex lighting
projects, and to control your network and all devices in it. For the
LAS to communicate with the network devices in the installation,
the LAS has to be adjusted to the same network as all the other
components. The next steps describe how to set the network
address in the LAS. For further details on the LAS, see the System
Manual e:cue LAS.
34

Application Settings

.
to apply the changes. The pop up window closes and
click on
Network
Interfaces
: