Mounting; Power Supply - OSRAM e:cue Lighting Control Engine 3 Bedienungsanleitung

5.1

Mounting

You can mount the Lighting Control Engine 3 (fx) in all standard
19-inch rack systems. Use the provided rack mounting rails and
screws to fasten the device in the rack:
Make sure that the server rack is sufficiently ventilated and proper
cage nuts and rack screws are used.
Connect the peripheral devices first. Ensure proper strain relief for
the connected cables. All cables, except Ethernet and relay
output, should not exceed a length of 3 meters. For the dry
contacts see page 19 and for the relay interfaces see page
20.
Use shielded network cables with shielding
!
connected to system ground.
5.2

Power Supply

Use the provided power cord to connect the supply voltage. Make
sure that the power cord is fastened to the LCE 3 (fx) by the clamp.
To turn on the device, switch the AC mains switch on.
Installation
29