Filling The Engine With Oil; Charging The Battery - Toro Super Bagger 20838 Bedienungsanleitung

3

Filling the Engine with Oil

No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
0.55 L (18.6 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 7
3. Add
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine-Oil Level (page
Important:
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
4

Charging the Battery

7).
No Parts Required
Procedure
Refer to Charging the Battery (page
g038772
6
(Figure
7 until the oil on the dipstick is at
Checking the
9).
If the oil level in the engine is too
18).
7).