Cleaning And Storing; After Every Use - Silvercrest SFAV 3.7 A1 Bedienungsanleitung

Moistening the cleaning pad
The water outlet openings 14 are located
on the underside of the sole 8. The cleaning
pad 9 is moistened through these openings.
1. Press the moisture button
moisture indicator 4 is lit green as long
as the cleaning pad 9 is being damp-
ened.
2. After a few seconds the moisture indica-
tor 4 goes out again and the process is
stopped.
3. Press the moisture button
ly until the cleaning pad 9 has the de-
sired level of dampness.
Cleaning windows or other
surfaces
WARNING! Risk of material dam-
age!
Do not use the window cleaner on sensi-
tive surfaces that can be easily
scratched.
1. Press the on/off switch 6 to switch on
the vibration of the sole 8. The power
and charging indicator 7 is lit green.
2. Hold the window cleaner with the clean-
ing pad 9 against the surface you wish
to clean while making circular move-
ments to clean it.
3. If the cleaning pad 9 becomes too dry,
press the moisture button
continue cleaning while doing so.
NOTES:
• For stubborn dirt, allow the moisture to
soak in briefly and then clean the area
again.
• The battery must be charged if the power
and charging indicator 7 is flashing red.
4. To stop cleaning, press the on/off
switch 6. The sole 8 stops vibrating
and the power and charging indica-
tor 7 goes out.
5. Wipe the cleaned surface with a squee-
5. The

8. Cleaning and storing

5 repeated-
WARNING! Risk of material dam-
age!
NOTE: after each use, pour out the remain-
ing water from the water tank 11 and store
the device with the lid open 1. This prevents
the formation of mould and germs in the de-
vice.

After every use

1. Pour any remaining water from the wa-
2. If you had added detergent or glass
5. You can
3. Remove the cleaning pad 9 from the
4. Wipe the housing of the window clean-
5. Wipe the power unit 10 with a dry, soft
6. Leave the lid 1 open and let all parts
gee or dry with a cotton cloth or cham-
ois leather.
DANGER! Risk of electric
shock!
Pull the power unit 10 out of the wall
socket before you clean the device.
Never immerse the device in water.
Do not use any astringent or abrasive
cleaning agents.
ter tank 11 through the filling open-
ing 15.
cleaner to the water:
- Rinse the water tank 11 with clear
water.
- Pour clear water into the water
tank 11.
- Press the moisture button
times to flush the system.
- Pour out the remaining water.
sole 8, wash it and wring it out.
er with a damp cloth.
cloth.
dry completely before putting them
away.
5 several
21
GB