Items Supplied; Unpacking; Charging; Operation - Silvercrest SFAV 3.7 A1 Bedienungsanleitung

4. Items supplied

1 window cleaner
1 cleaning pad 9
1 Power unit 10
1 copy of the user instructions

5. Unpacking

• Remove all packing material.
• Check to ensure that all parts are pres-
ent and undamaged.

6. Charging

NOTES:
• Before the device is used for the first
time, and during the following three
charging procedures, the device should
be charged for 3.5 hours in each case.
• When the battery is almost flat, the
power and charging indicator 7 flashes
red. The device can then only be used
for a short time without being connected
to the electricity supply.
• When the battery is fully charged, the
device can be used for approx.
35 minutes without being connected to
the power supply.
• It is best to charge the window cleaner
after each use before putting it away.
This saves the battery and the window
cleaner is immediately ready for use the
next time you need it.
1. Switch off the device with the on/off
switch 6 if necessary.
2. Connect the power unit 10 to the con-
nector 3 on the back of the handle 2 of
the device.
3. Insert the power unit 10 into a readily
accessible wall socket whose voltage
matches the voltage stated on the pow-
er unit. The power and charging indi-
cator 7 is lit red and the battery is
charged.
20 GB
4. When the battery is fully charged, the
power and charging indicator 7 is lit
green. Disconnect the power unit 10
from the wall socket and then the coax-
ial power connector from the connec-
tor 3.

7. Operation

Attaching the cleaning pad
The cleaning pad 9 has two different sides:
- Figure A: the side with the mesh struc-
ture is the cleaning side.
- Figure B: the other side (Velcro side) is
attached to the Velcro points 13 on the
sole 8.
• Attach the Velcro side of the cleaning
pad 9 to the Velcro points 13.
Filling the water tank
DANGER! Risk of electric
shock due to moisture!
Pull the power unit 10 out of the wall
socket before you fill the water tank.
WARNING! Risk of material dam-
age!
Only fill the water tank 11 with cold,
clear tap water. Do not use chemical
substances, cleaning agents or other liq-
uids. Single exception: you can use a
few drops (1 to 3) of mild detergent or
glass cleaner concentrate (to dissolve in
the cleaning water).
Do not use abrasive or harsh cleaning
agents with the window cleaner.
1. Figure D: open the lid 1.
2. Fill cold, clear tap water through the fill-
ing opening 15 at most up to the MAX
mark 12.
3. If desired, add 1 to 3 drops of mild de-
tergent or glass cleaner concentrate to
the water.
4. Figure D: close the lid 1 and press it
firmly closed.