Chapter 1. Description Of The Appliance; Chapter 4. Trouble­shooting And Service - clage DSX Touch Beiblatt Zur Gebrauchs­ Und Montageanleitung

Amendment DSX Touch Twin GA
This amendment shows the modifications of the appliance regarding
attached manual.
This sheet has to be kept together with the manual.
Supplements

Chapter 1. Description of the appliance:

DSX Touch Twin system is for a parallel water supply to one or more tap con-
nections with a high hot water demand with two special programmed DSX
Touch Twin water heaters.
With this special Twin software the appliances in a functional group will be
synchronized. The temperature settings will be adapted by all appliances auto-
matically and the consumption data of all appliances can be read out by the
CLAGE Smart Control app via smart phone or tablet.
The DSX Touch Twin I serves in this group as a control unit and forwards all
temperature changes to the DSX Touch Twin II.
It can be operated directly on the device, via remote control or via the Smart
Control App with a smart phone / tablet.
Note: A slight delay in temperature change is normal.
Chapter 2. How to use:
Settings
Temperature Limit: In group operation mode the temperature limit must be
set on the same value at all appliances of the group.
Flow Limit: If a flow limit is required, it must be set the same on all appliances.
Chapter 3. Remote control:
Registration of remote control at the instant water heater
The remote control can only be registered at the DSX Touch Twin I. For the
DSX Touch Twin II the remote control function is disabled.
Chapter 4. Trouble­shooting and service
Problem Cause
Temperature can be Temperature limit is not
selected higher than set on all appliances of
temperature limit the group
5
CLAGE
Solution
Set the same temperature limit
for all appliances