Installing Connection Pieces; Installing The Appliance - clage DSX Touch Beiblatt Zur Gebrauchs­ Und Montageanleitung

DSX Touch Twin
Amendment DSX Touch Twin MA
Supplements
Chapter 5. Installation:
Installation site
• For a group operation the water pipes of the appliances must be connected
via the Tichelmann-principle. Suitable piping is already pre-assembled in the
Twin flush-mount cabinet.
• Both DSX Touch Twin must be installed in the flush-mount cabinet.
Installing the wall bracket
Note: The wall brackets are preassembled in the cabinet.

Installing connection pieces

Note: Fasten the screw nuts with caution, to avoid damage to the valves or
the piping system.
1. The two ½ inch screw-in nipples and the ½ inch seals must be screwed into
the ½ inch union nuts of the hot-water and cold-water connectors.
2. Remove the two ½ inch caps of the side outlets of the hot-water and cold-
water connectors and mount them onto the open end of the screw-in nip-
ples.
3. Screw the ½ inch side outlets of the hot-water and cold-water connectors
with the ½ inch union nuts of the preassembled manifolds, together with
the ½ inch seals.
4. Repeat the steps 1 - 3 with the connecting pieces of the second appliance.
5. The hot-water and cold-water connectors must then be screwed into the
⅜ inch union nut of the appliance, together with the ⅜ inch seals.
Note until installation: put the strainer into the cold water connection!

Installing the appliance

Note: Open the water supply only after the installation of both DSX Touch
Twin. Otherwise water will leak from the supply lines of the missing device.
Mounting the remote control's wall bracket
Note: Test the radio contact with closed cabinet cover before attaching the
bracket.
6