C) Inspection And Care; Maintenance And Control; Cleaning And Care - FireBird VIPER M Betriebsanleitung

C) INSPECTION AND CARE

1. Life span and construction repair hints
The belt system FIREBIRD VIPER was conceived for high loads and extreme
demand. Accordingly with the choice of the materials particularly high criteria where
set. Since however the life span is dependent in high measure on the user, we
recommend examination of wear and damaged components each time before
flying.
In particular it is to be made certain that defective seams are renewed immediately
by an authorized workshop. We recommend to you in such a case the repair
directly with Firebird.
In order to prevent an unnecessary attenuation of the belt group, we recommend:
Ø avoid fire and sharp edged articles in direct proximity of the belt system.
Ø avoid unnecessary long exposure to the sun effect, because ultraviolet radiation
destroys the molecular structure of the material.
Ø avoid contact with seawater or acid liquids
Ø remove marks and heavy stains as quick as possible with warm water.

2. Maintenance and control

The belt system FIREBIRD VIPER is maintenance-free. Most careful processing as
well as the use of high-quality materials makes this belt system a very long-lived
product. Regular control in short periods gives you the best guarantee of an
unrestricted function of your belt system.

3. Cleaning and care

For the cleaning of your belt system should pay attention not to use hard solvents.
For the success of the cleaning the cleaning agent is not crucial, but the period after
that the cleaning takes place. Clean your belt system with warm water or, with
persistent dirt, with a curd soap caustic solution.
4. Compatibility with gliders
With the configuration of the Firebird VIPER, can be used without restriction for all
gliders.
FOR REPAIR WORK, SUGGESTIONS FOR IMPROVEMENT, OR INFORMATION
THE TEAM IS ALWAYS AT YOUR SERVICE
24