Overheat Protection - Philips HR1372 Bedienungsanleitung

If the mains cord is damaged, it must be replaced by Philips, a
,
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
Switch off the appliance and disconnect it from the mains before
,
you change accessories or approach parts that move during use.
Never immerse the motor unit in water or any other liquid, nor
,
rinse it under the tap. Only use a moist cloth to clean the motor
unit.
Never let the appliance run unattended.
,
This appliance is not intended for use by persons (including
,
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with
,
the appliance.
Do not allow children to use the appliance without supervision.
,
This appliance is intended for household use only.
,
Do not exceed the quantities and processing times indicated in the
,
table.
Do not process more than three batches without interruption. Let
,
the appliance cool down to room temperature before you continue
processing.
Never touch the blades when the appliance is plugged in. The
,
blades are very sharp.
If the blades get stuck, unplug the appliance before you remove the
,
ingredients that block the blades.
Noise level: Lc = 70 dB [A]
,

overheat protection

This appliance is equipped with overheat protection. If the appliance
overheats, it switches off automatically. Unplug the appliance and let it
cool down for 5 minutes. Then put the mains plug back into the wall
socket and switch on the appliance again. Please contact your Philips
dealer or an authorised Philips service centre if the overheat protection is
activated too often.
EnglisH
7