Operation - Cameo ZENIT W600 D Bedienungsanleitung

PLEASE NOTE:
• As soon as the spotlight is correctly connected to the power supply, the following will be displayed in succession: "Welcome to Cameo",
the model name and the software version. After this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the currently programmed DMX address is
displayed and the characters on the display will begin to flash.
• After approximately 1 minute of inactivity, the display will automatically show the currently active operating mode.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previously
selected menu items and sub-menu items. 1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item, where
you can make changes instantly as required (DMX starting address and all modes). 2 Press MODE for direct access to the last-selected and
last-edited menu item. Press ENTER repeatedly to access the sub-menu items in order to change individual settings (DMX starting address and
all modes).
• Before changing device settings, ensure that the control panel is dry and dust free, in order not to impair its functionality.
• The display can be rotated through 180° by pressing UP when the main display is visible.

OPERATION

MAIN DISPLAY
After the power-up process, the lamp is ready for operation and starts in the previously activated mode. The main display appears with the
following information: current mode (in the example DMX mode) and W-DMX™ status.
W-DMX™ status
DMX Address
001
Current operating mode
W-DMX™
1. To pair with W-DMX™-compatible transmitters, enable W-DMX™ in the device settings (Settings -> Wireless Setting -> W-DMX On Off
-> On) and reset the W-DMX™ module (Receive Reset -> Yes). Start the pairing process as described in the operating instructions of the
W-DMX™ transmitter. Pairing is then completed automatically.
2 Pair a group of W-DMX™ devices to create a DMX universe with them. First unpair all devices that are to make up the group (Settings ->
Wireless Setting -> Receive Reset). Then select a CLZW600 with a DMX controller via DMX cable and select "Transmit" in the settings (Set-
tings -> Wireless Setting -> Operating Mode -> Transmit). Select "Receive" in the settings of the W-DMX™ device that you want to control
via W-DMX™ (Settings -> Wireless Setting -> Operating Mode -> Receive), and pair it by selecting "Link" in the settings of the DMX cable
controlled CLZW600, then confirm your selection (Settings -> Wireless Setting -> Link -> Link). Pairing is then completed automatically.
3 It is also possible to create a connected group of W-DMX™ devices via W-DMX™, and operate them in master/slave mode. First unpair
all devices that are to make up the group (Settings -> Wireless Setting -> Receive Reset). In the settings (Settings -> Wireless Setting ->
Operating Mode) of the master unit select "Transmit", and in the settings of the slave units select "Receive". On the master unit select
"Link" (Settings -> Wireless Setting -> Link -> Link) and confirm your selection by pressing ENTER. Pairing of the devices is then completed
automatically. Select standalone mode in the master unit and use this to control the slave units (same model).
6