Cameo ZENIT W600 D Bedienungsanleitung Seite 7

W-DMX™ STATUS
W-DMX™ W-DMX™
deactivated activated as
receiver,
not paired
SET DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "DMX
address" (observe arrow) and confirm with ENTER. The display will show a three-digit number field and you can use the UP and DOWN
controls to configure the desired DMX start address. Confirm the entry with ENTER and press MODE to return to the main display (in the
example, "DMX address 001").
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
SET DMX MODE (DMX Mode)
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "DMX Mode" (observe
arrow) and confirm with ENTER. In the sub-menu you can use UP and DOWN to choose between the DMX modes "1CH", "2CH", "3CH",
"4CH" and "6CH". Confirm your selection with ENTER. DMX tables with the channel assignments can be found in these instructions under
DMX CONTROL.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
W-DMX™ W-DMX™
activated as activated and
receiver and device paired,
device paired, no DMX signal
transmitter
deactivated or
out of range
001
-
DMX Address
001
5xx
------------ DMX MODE ------------
6CH
4CH
3CH
2CH
1CH
W-DMX™ W-DMX™ and
activated as transmission
receiver and mode G3
device paired, activated
DMX signal is
Upward arrow =
present sending
Downward ar-
row = receiving
Arrow flashing =
pairing
Flashing stops =
paired
G3 G4S
W-DMX™ and
transmission
mode G4S
activated
Upward arrow =
sending
Downward ar-
row = receiving
Arrow flashing =
pairing
Flashing stops =
paired
7