Connections, Operating And Display Elements - Cameo ZENIT W600 D Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1 3
1 POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100 – 240 V AC / 50 – 60Hz. Connection via supplied power cable
(when not in use, always close with rubber sealing cap).
POWER OUT
2
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO spotlights. Ensure that the total current
consumption of all connected devices does not exceed the value specified on the device in amperes (A) (when not in use, always close with
the rubber sealing cap).
DMX IN
3
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in use, always close with the rubber sealing cap).
4 DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with the rubber sealing cap).
5 OLED DISPLAY
Displays the current operating mode and other system settings.
TOUCH-SENSITIVE CONTROLS
6
MODE
Press MODE to access the system settings selection menu. Press repeatedly to return to the main display.
ENTER
Press ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm changes by pressing ENTER.
UP and DOWN
Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to be made to
a menu item setting such as the DMX address as required.
PRESSURE EQUALISATION ELEMENT
The pressure equalisation element to prevent condensation inside the housing is in the device base, behind the cable feed for the LED unit.
In order to ensure its proper function, the element must be protected from contamination.
HOUSING FAN
The 3 housing fans and the heat sink are on the back of the LED unit. Ensure air circulation by not covering the device, and cleaning it regularly.
TIPS: In order to provide protection from spraying water, in accordance with protection class IP65, special IP65-rated XLR connectors must
be used correctly with the DMX input and output sockets, or they must be closed using the rubber sealing caps. When connected correctly,
or when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT sockets are protected from spraying water, as in
accordance with IP65.
6 5 6
4 2
5