Connection; Unpacking; Belt Clip; Connecting The Telephone - AUDIOLINE DECT 3000micro Bedienungsanleitung

AUDIOLINE DECT 3000micro

1. CONNECTION

1.1

UNPACKING

The following parts will be found in the package:
Handset
Base station
3 NiMh batteries
Operating instructions
1.2

BELT CLIP

If you want to carry your AUDIOLINE DECT 3000micro with you at all times, you
can use the fixing clip to fix the handset to your belt, for example.
1.3

CONNECTING THE TELEPHONE

Connect the telephone cable supplied to the telephone socket and the
telephone jack "TEL" on the underside of the base station. The AUDIOLINE
DECT 3000micro uses Touch-Tone Dialling (TTD) and can be switched over
to the older Pulse Dialling system if necessary. More information is provided
in the chapter on "Base Station Settings".
Insert the power supply plug into the socket (PWR) on the underside of the
base station and plug the power supply into a properly installed mains
socket.
Open the battery compartment in the handset by sliding the cover of the
battery compartment away from the handset using light pressure on the
lower end. Now insert the batteries taking care to ensure that the polarity is
correct. Close the battery compartment.
Place the handset on the base station with the display to the top or to the
bottom. The charging light on the base station will come on. Before being
used for the first time, the handset must be charged continuously for 18
hours.
Belt clip
Power supply
Telephone cable
CONNECTION
49