Werbung
INSTALLATION
2.
INSTALLATION
2.1
CONNECTING THE RECEIVER
After unpacking your telephone, you must first connect the telephone
receiver to the base unit. The spiral cable needed for this has two
identical connections so that there can be no confusion. First take one
end of the spiral cable and plug it into the socket at the bottom of the
receiver. Now plug the other end into the socket on the left-hand side of
the base unit.
2.2
INSERT BATTERY
Before connecting your new telephone to the telephone network, the
supplied battery should be installed. Please always use type AAA 1.5V
alkaline batteries. The batteries are required for the display and other
features of the telephone. Before installing or changing the batteries
make sure that the telephone is not connected to the telephone
network. The battery compartment is to be found on the underside of
your telephone.
1. Open the battery compartment with a small screwdriver or a pointed
object.
2. Insert the battery. Ensure that the polarity is correct. Push the "-" pole
onto the small spring and then press the "+" pole downwards.
3. Close the battery compartment.
The battery must be changed when the display is no longer visible.
2.3
CONNECTING THE TELEPHONE
Connect the telephone cable provided to the telephone jack and the
telephone socket on the rear of the telephone. The AUDIOLINE
Telephone 48G works using the TTD system (Touch-Tone Dialling).
20
TELEPHONE 48G
Werbung
