Starting The Engine - Toro CCR Quick Clear 6053 Bedienungsanleitung

•
Exercise extreme caution when operating the
machine on a slope.
•
Do not operate the machine without good visibility
or light.
•
Look behind and use care when backing up the
machine.
•
When not actively clearing snow, disengage power
to the auger.
•
Exercise extreme caution when operating the
machine on walks or roads. Stay alert for hidden
hazards or traffic.
•
Never attempt to make any adjustments while
the engine is running, except as directed in the
instructions.

Starting the Engine

Note:
Remove your glove when you push in the primer so that air cannot escape from the primer hole.
Important:
Do not use the primer or the choke if the engine has been running and is hot. Excessive
priming may flood the engine and prevent it from starting.
Standard Models
•
After striking a foreign object, shut off the engine,
remove the key, and inspect the machine for
damage. Repair any damage before starting the
machine.
•
If the machine starts to vibrate abnormally, shut off
the engine and check immediately for the cause.
•
Do not run the engine indoors; exhaust fumes are
dangerous.
•
Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
•
Shut off the engine whenever you leave the
operating position, before clearing or unclogging
the collector, rotor, or discharge chute, and when
making any repairs, adjustments, or inspections.
Figure 10
9
g257388