Herunterladen Inhalt Inhalt Diese Seite drucken

Changing The Engine Oil - Toro CCR Quick Clear 6053 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Changing the Engine Oil

Service Interval: After the first 2 hours
Yearly
If possible, run the engine for a few minutes before
changing the oil to warm it. Warm oil flows better and
carries more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
*There is residual oil in the crankcase after you drain
the oil. Do not pour the entire capacity of oil into the
crankcase. Fill the crankcase with oil as directed in
the following steps.
1.
Siphon the fuel from the fuel tank into an
approved fuel container, or run the engine until
it shuts off.
2.
Move the machine to a level surface.
3.
Place an oil-drain pan under the oil-drain plug,
remove the plug, and tip the machine backward
and drain the used oil in the pan
Figure 21
4.
After draining the used oil, return the machine to
the operating position.
5.
Install the oil-drain plug and tighten it securely.
6.
Clean around the oil fill/dipstick.
7.
Unscrew the dipstick and remove it
0.60 L (20 fl oz)*
Refer to
Figure
23.
SJ or higher
(Figure
21).
g006372
(Figure
22).
1. Dipstick
8.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
Note:
You may tip the machine forward (handle
up) a little to make adding oil easier. Remember
to return the machine to the operating position
before checking the oil level.
Important:
Do not tip the machine all the
way forward onto its nose, or fuel may leak
out of the machine.
Use
Figure 23
the outdoor temperature range expected.
9.
Wait 3 minutes for the oil to settle in the engine.
10.
Wipe the dipstick clean with a clean cloth.
11.
With the machine in the operating position,
insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
12.
Read the oil level on the dipstick.
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat
15
Figure 22
to select the best oil viscosity for
Figure 23
g006316
g011606

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

3856338568

Inhaltsverzeichnis