Cameo FLAT PRO 7 G2 Bedienungsanleitung Seite 8

CONFIGURE DMX MODE
Press MENU to access the main menu. Now use UP and DOWN to select the menu item DMX Mode and confirm with ENTER. Again use UP
and DOWN to select the desired DMX mode and confirm with ENTER. Tables with the channel assignment of the different DMX modes can
be found in these instructions under DMX CONTROL.
DMX DELAY
The DMX Delay function is a simple way to create a running light effect with a large number of spotlights that are all the same model
and that are all running the same software version. This is otherwise only achievable with a suitable DMX controller and time-consuming
programming. All the spotlights used in this are set to the same DMX operating mode and controlled via the same DMX start address.
The delay time (DMX signal delay) can be manually set on each spotlight with different delay times (DMX Delay by DMX? No) or with the
same delay time for all spotlights via a connected DMX controller on a specially reserved DMX channel (DMX Delay by DMX? Yes).
Starting from the main display, press MENU to enter the main menu. Now use UP and DOWN to select the menu item DMX Delay and con-
firm with ENTER. Again use UP and DOWN to select the desired submenu item, confirm with ENTER and set the value or status accordingly.
Confirm all entries with ENTER.
Assign the spotlights to one of up to 24 groups according to preference, whereby several spotlights can be assigned to one group. The group
number is also the factor by which the set delay time is multiplied (see setup example).
Spotlight (group) 0 Spotlight (group) 1 Spotlight (group) 3 Spotlight (group) 3 Spotlight (group) 4 Spotlight (group) 5
No delay 0.5 s delay 1 s delay 1.5 s delay 2 s delay 2.5 s delay
8