Cameo FLAT PRO 7 G2 Bedienungsanleitung Seite 10

CCT STANDALONE MODE (CORRELATED COLOR TEMPERATURE)
The CCT standalone mode allows the color temperature to be adjusted from 1800 K to 7500 K in 100 K steps, and the tint and brightness
(dimmer) can also be adjusted.
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select the Standalone menu item and confirm
with ENTER. Using UP and DOWN, select the standalone mode CCT and confirm with ENTER. Now select the menu item you wish to edit
using UP and DOWN, confirm with ENTER and adjust the desired value using UP and DOWN. Confirm all entries with ENTER.
COLOR PRESET STANDALONE MODE
15 different color presets are available. The brightness can be separately set for each preset.
Starting from main display 1, press MENU to enter the main menu. Using UP and DOWN, select the menu item Standalone and confirm
with ENTER. Using UP and DOWN, select the standalone mode Color Preset and confirm with ENTER. Now use UP and DOWN to select the
desired color as a preset and confirm with ENTER (Color Off = blackout). You can set the desired brightness from 000 to 100 using UP and
DOWN, confirm all entries with ENTER.
USER COLOR STANDALONE MODE
The User Color standalone mode allows you to store four individual color presets for overall brightness, strobe and a color blend of R, G, B,
W and A directly in the device.
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select the menu item Standalone and confirm
with ENTER. Again use UP and DOWN to select the standalone mode User Color and confirm with ENTER. Using UP and DOWN, now select
the desired preset (Color 1 - Color 4) and confirm with ENTER. Using UP and DOWN, now select the menu item that you wish to edit and
confirm with ENTER. You can use UP and DOWN to configure the desired value between 000 and 255. The strobe effect values correspond to
those in channel 2 of the DMX table 4 CH Mode 1. Confirm all entries with ENTER.
LOOP STANDALONE MODE
The Loop standalone mode allows you to individually configure, store and access up to four different color changing programmes. Bright-
ness, step time, fade time and delay (signal delay) are also separately configurable.
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select the menu item Standalone and confirm
with ENTER. Using the UP and DOWN buttons, select the standalone mode Loop and confirm with ENTER. Using UP and DOWN, now select
the desired loop (Loop 1 to 4) and confirm with ENTER.
10