Installation; Transport And Storage; Unpacking; Installation Requirements - Grundfos Conex DIA-2 Installationsanleitung

9. Installation

9.1 Transport and storage

• Transport the device carefully, do not drop!
• Store at dry and cool location.

9.2 Unpacking

1. Check the device for damage.
Install as soon as possible after unpacking.
2. Do not install or connect damaged devices!
Retainthe packing material or dispose of it
Note
according to local regulations.

9.3 Installation requirements

• Dry room
• Room temperature: 0 °C to 45 °C
• Vibration-free location.
If you do not observe the installation
requirements, the device may be
Caution
damaged!
The measurements may not be correct!

9.4 Installation in control panel

92
+0.8
92 +0.8
> 20
Fig. 4 Control panel enclosure Conex
Fig. 5 Sensor interface
1. Make an opening of 92 + 0.8 mm x 92 + 0.8 mm
in the control panel.
2. Slip on the supplied gasket.
®
3. Insert the Conex DIA-2 into the opening from
the front.
Do not damage the gasket!
Caution
The gasket must be fitted exactly!
1. Hook the clamps into the tightening cones on the
sides at the top and bottom.
2. Secure the device from the rear using a
screwdriver.
3. Install a separate sensor interface near the
sensors (maximum distance of three metres).
> 20
®
DIA-2
15