Setup - Grundfos Conex DIA-2 Installationsanleitung

11.5 Setup

All standard settings of the device can be defined in
the "setup" menu. During initial commissioning,
basicHfunctions are configured which after that
should only be altered rarely or even not at all.
The "setup" menu can only be accessed by persons
having full rights.
See section 11.5.8 Code
Enter the code number.
11.5.1 Selection of measured values for chlorine, chlorine dioxide, ozone, peroxide and pH
setup
parameter 1
off
chlorine
chlorine dioxide
ozone
parameter 2
off
pH
Fig. 26 Selection of measured value in menus "parameter 1" and "parameter 2"
* pH-comp. chlorine is only available if chlorine and pH have been selected as parameters.
1. Select the line "parameter 1" / "parameter 2" using the [Up] and [Down] buttons, and press [OK] to switch to
the corresponding menu.
2. Use the [Up] and [Down] buttons to select the measured variable (parameter). Press [OK] to confirm.
3. Use the [Up] and [Down] buttons to select further settings. Press [OK] to confirm.
function.
temp. meas.
on
off
temp. meas.
on
off
temp. comp.
on
off
pH-comp. chlorine *
on
off
temp. meas.
on
off
31