Selection, Configuration And Parameterisation Of The Controller - Grundfos Conex DIA-2 Installationsanleitung

11.6 Selection, configuration and
parameterisation of the controller
It takes two steps to set up the controller:
• First: selection and configuration of the controller
type in the "setup" menu, "controller" submenu.
• Secondly: parameterisation of the selected
controller type in "main menu", "controller"
submenu.
11.6.1 Selection and configuration of the controller
setup
controller
parameter 1
setpoint contrl.
controller
parameter 2
parameter 2
as controller
parameter 1
Fig. 30 Selection and configuration of the controller
• In the "setup" menu, select the line "controller parameter 1" or "controller parameter 2" using the [Up] and
[Down] buttons, and select the menu with the same name using [OK].
setpoint contrl.
off
limit contact
interpulse ctrl.
pulse freq. ctrl.
cont. controller
Limit contact
downward viol.
upward violation
ctrl. direction
downward control
upward control
ctrl. charact.
P
PI
PID
37