Installation; Measuring The Dimensions; Fastening The Pillar Brackets; Marking The Am And Ah Axes - SOMFY EXAVIA Montage- Und Gebrauchsanleitung

1

Installation

1.2 Fastening the pillar brackets

Marking the AM and AH axes

1. Transfer dimension B onto the pillar using the hinge axis and mark
a vertical axis AM on the pillar.
2. Mark the horizontal axis AH on the pillar, halfway up the rein-
forcement.
Check before proceeding to the next step
Have you marked the AM and AH axes?

Drilling the pillars

1
AH
Align the markings made on the bracket with the AH axis and
align the edge of the bracket with the AM axis.
Note: The markers marked on the bracket are underneath the
oblong holes.
2
Check that the bracket is horizontal, then mark the mounting
holes for the bracket.
13
EN - EXAVIA installation and operating guide - SOMFY
AH
Position the bracket in direction e or E defined in step 2 of
measuring the dimensions (see page 12)
Le -hand pillar
Direction E Direction E
or
Take care to ensure the bracket is fitted the right way up.
Correct orientation
3
Drill 3 holes in each pillar at the marked locations (see page
11 for the drilling diameter corresponding to suitable
hardware).
Right-hand pillar
Direction E Direction E
or
Incorrect orientation