Troubleshooting; Possible Cause - Scheppach bts900 Original Bedienungsanleitung

15. Troubleshooting

Problem

Possible cause

a)
b)
c)
Motor doesn't start d)
e)
Machine gets slower Too much pressure put on the
during work. workpiece.
Sanding belt comes Belt does not run straight.
off the drive pulleys.
a)
The wood gets burnt
during sanding. b)
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
ON/OFF switch damaged.
ON/OFF cable damaged.
ON/OFF relay damaged.
Fuse blown.
Motor burnt.
Sanding disc or belt covered
with grease.
Excessive pressure on work-
piece.
Help
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every at-
tempt to carry out a repair, can be danger-
ous if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a) Replace disc or belt.
b) Reduce pressure on workpiece.
GB | 27