Changing Of Mains Voltage Range To 380 / 415V - Fronius TransArc 150 Leybold Bedienungsanleitung & Ersatzteilliste

Start-up ramp time: 3 jumpers
Designation AZ0 - AZ2
000 0.25 s
001 0.5 s
010 0.75 s
011 1.0 s
100 1.25 s
101 1.5 s
110 1.75 s
111 2 s
Start-up ramp voltage: 3 jumpers
Designation AS0 - AS2
000 7.5 V
001 15.0 V
010 22.5 V
011 30 V
100 37.5 V
101 45 V
110 52.5 V
111 60 V
CHANGING OF MAINS VOLTAGE RANGE TO
380 / 415V
3 KOMPONENTS HAVE TO BE CHANGED
Change the bridge on the STP4 to 380V or 415V
The transformer STPSP must be soldered to the right connec-
tions
380V: middle connection of transformer - two wires
415V: end connection of transformer - one wire
Attention! Before starting of the power source you have to
check the output voltages on the STPSP X14 / X15,
4 x 9,6V +/- 10%.
If this voltages are not allright the power module can be
destrojed.
Change the PWM pcb.
Order.no.: 380V - 4.070.169
415V - 4.070.172
Fig. 4
15