Rewind Key; Zera,Reset Button (12) For Counter; Record Level Contral (14) And Level Meter; Monitor Volume Control Vol - uher 4000 REPORT MONITOR Bedienungsanleitung

NOTE:
To prevent deformation of the rubber pressure roller, always
return the START key to its neutral position before switching
the machine off.
3.7 Rewind Key ...... (24)
Press this key to switch the machine to fast rewind mode.
To stop fast rewind, press the STOP key (21).
3.8 Zero-Reset Button (12) 10r Counter (13)
Pressing this button returns the index counter reading to 000.
Ta facilitate IDeation of the desired spot on the tape upon sub-
sequent playback, it is advisable to press the reset key cr to
note the starting index number befors commencing each re-
cording.
3.9 Battery Cheek Key BATT. (11)
Press down this key while the machine is switched on, and
the level meter (16) will indicate battery strength at that mo-
ment. As long as the pointer remains in the green segment of
the meter scale, the power supply is suffieient for flawless
operation (see also sec. 1.1.2).
3.10 LIGHT Switeh (10) wilh Automatie Time Switehing for
Meter Illumination
Pressing the LIGHT switch once switches on the meter illumina-
tion for approximately 15 seconds. Pressing the switch twice
in succession will cause the light to remain on.
The continuous illumination may be switched off by pressing
the LIGHT switch once.
The illumination may be turned off even betore the 15 seconds
have expired: simply press the LIGHT switch twice in succession.
To save power when the 4000 REPORT MONITOR is powered
by dry eells or storage battery, it is advisable to use the auto-
matie time switching tor meter illumination.
3.11 Reeord Level Control (14) and Level Meter (16)
Use this contral (14) to set the machine to the optimal record
level (see sec. 7 "Record Operation"). the meter (16) will indi-
cate the level during both record and playback.
3.12 Monitor Volume Contral VOL. (9)
This knob is for regulating volume during record or playback
when monitoring through the built-in loudspeaker, an external
speaker or headphones. Position detents prevent accidental
alteration of the volume level setting.
3.13 TONE Control (8) with On/OffSwiteh lor Built-In
Speaker
This knob regulates the playback of high frequencies. With the
knob in position 10, the high frequencies will not be atfected.
Treble de-emphasis will be maximal when the knob is in 0
position.
Pull out the knob (8) to switch off the built-in loudspeaker
Controls (8) and (9) do not affect the recorded signal.
3.14 ALC Switeh (18)
UHER 4000 REPORT MONITOR is equipped with an automatie
record level contral.
27