Sharp XR-1X Serviceanleitung Seite 28

XR-1X
No. Adjusting point
7 Auto keystone
initialization
8 Adjustment of
DLP voltage
9 Adjustment of
RGB brightness
10 Adjustment of
Component
offset
11 Adjustment of
DLP Brightness
12 Adjustment of
Video Brightness
13 Adjustment of
Video Tint
Downloaded from www.Manualslib.com
Adjusting conditions
1. Select the following group
and subjects.
Group : ADJUST
CW/Auto KS
Subject : CAL
1. Read voltage rank of DLP
description.
2. Set the switch correspond-
ing to the rank which has
been read.
1. Select the following group
and subjects.
Group : CONFIRM/AD
Subject : R-BRIGHT
G-BRIGHT
B-BRIGHT
(Process GAMMA interlock)
1. Feed 10-step signal with
480P component 100%
amplitude.
2. Select the following group
and subjects.
Group : CONFIRM/AD
Subject : C-R-OS
C-B-OS
(Process GAMMA interlock)
1. Select the following group
and subject.
Group : CONFIRM/DLP
Subject : R-BLK
G-BLK
B-BLK
(Process GAMMA interlock)
1. Feed NTSC 100% wind pat-
tern signal. (Signal with
burst)
2. Select the following group
and subject.
Group : CONFIRM/VIDEO
Subject : V-BRIGHT
1. Feed split color bar.
2. Select the following group
and subject.
Group : CONFIRM/VIDEO
Subject : V-HUE
manuals search engine
Adjusting procedure
Check that the K-SENS value is 0 ± 3.
Check that keystone is caused by tilting the unit.
1. Carry out adjustment when DLP chip has been re-
placed or combination of chip and formatter has been
changed.
Rank: B C D E
Setting value: 1 2 3 4
1. Check the fixed value.
Fixed value : 127
1. Check the fixed value.
C-R-OS : 256
C-B-OS : 256
1. Check the fixed value.
Fixed value : 256
1. Check the fixed value.
Fixed value : 72
1. Check the fixed value.
Fixed value : 128
28