Panasonic AW-E750E Bedienungsanleitung Seite 36

w BLACK BALANCE ADJUSTMENT
• Close the lens.
If the motor drive lens is controlled from the camera, the
lens is automatically closed when the black balance is
adjusted.
• When the camera is used without a RCU or ROP,
R/B pedestal adjustment of painting setting will be
automatically reset to ±0 after setting the black balance.
(painting setting in only USER MODE.)
[ADJUSTMENT by CAMERA]
Press the YES/ABC Switch for over 2 seconds and the black
balance will be set automatically in 10 seconds.
In user mode, black balance fine adjustment can be
performed with the red pedestal/blue pedestal setting after
setting the black balance.
YES/ABC Switch
[ADJUSTMENT with the RCU, ROP or multi hybrid
control panel]
In the case of the RCU, set the auto white/auto black
selector switch to the ABC position.
In the case of the ROP or multi hybrid control panel, the
black balance is set when the ABC button is pressed.
While the black balance is being set, the auto setting
indicator LED or ABC button lamp flashes. If the setting is
established successfully, the LED or ABC button lamp will
go off, but if it is not established successfully, it will light up.
If the setting is not established successfully, proceed with
the setting again.
Auto setting indicator
Remote control unit
ABC button
Remote operation panel
- 35 (E) -
ABC button
Multi hybrid control panel