Panasonic AW-E750E Bedienungsanleitung Seite 12

Parts to be provided by the customer for installation
When the unit is to be mounted onto a Panasonic pan-tilt
head, use the mounting screws and drop-prevention wire
that are supplied with the pan-tilt head.
Provide the following parts when the unit is to be mounted
onto a surface other than a pan-tilt head.
Drop-prevention wire* (sold separately): 1
(*Be absolutely sure to use the drop-prevention wire.)
Drop-prevention wires in three different lengths (300 mm,
450 mm and 600 mm) are available as optional
accessories.
Use a wire in the length that will have no slack to suit the
installation location and installation method.
Consult your dealer when you purchase one of these
drop-prevention wires.
Wire length (300, 450 or 600 mm)
ø6.5
( Camera
ø4.2
side)
Wire length (mm)
300 3CN001064BAA
450 3CN001064BAB
600 3CN001064BAC
ø6.5
( Installation
ø4.2
side)
ø1.2
Parts number
Mounting screws (Inch screws: 1/4-20UNC): 2
(For mounting the camera)
Determine the length
of these screws by
factoring in the thickness
of the camera mounting
bracket.
Mounting screws (M6) for installation end wire
At the installation location, be absolutely sure to use
the anchor bolts, and ensure that the strength of the
installation surface is at least ten times the total mass of
all units installed.
Flat washers for use with 1/4˝ screws: 2
(For mounting the camera)
Spring washers for use with 1/4˝ screws: 2
(For mounting the camera)
11 mm Camera mounting bracket: 1
Use a bracket made of a material and having a shape
that is strong enough to support the total mass of all units
installed, including the camera and lens.
To determine the position of the holes used for mounting
the camera, refer to <Bottom view> on page 12, and
make holes with a diameter of 7 mm (to support 1/4-
20UNC mounting screws).
- 11 (E) -
Camera
mounting bracket
7 to 9 mm