Panasonic AW-E750E Bedienungsanleitung Seite 35

w MANUAL WHITE BALANCE SETTING
[ADJUSTMENT by CAMERA or multi hybrid control
panel]
Manual setting is possible in USER MODE only.
1. Select the white balance mode either AWC A or
AWC B by menu.
2. Aim the camera at a large white object. Press the
ITEM/AWC switch for over 2 second.
3. Adjust the red gain/blue gain control in the
PAINTING item of Colour Set sub menu of USER
MODE until the carrier wave of the white portion of
the video signal is at the minimum width or the white
object in the monitor screen appears pure white.
(Use an oscilloscope or a waveform monitor for
precise adjustment.)
For details on the menu operations using the multi hybrid
control panel, refer to the Operating Instructions of the
multi hybrid control panel.
[ADJUSTMENT with the RCU or ROP]
After AWC setting, adjust the R/B GAIN controller in the
same way as described in Step 3 above.
Minimize the carrier wave using
the red & blue gain controls
w RESET TO 3 200K OR 5 600K WHITE
BALANCE
When the white balance setting is set to either "P SET
3 200K" or "P SET 5 600K" the white balance will be
automatically set to the colour temperature 3 200K or
5 600K, respectively.
- 34 (E) -
Waveform for white
balance set chart