Fuse Check/Replacement/Reset - Nilfisk SR 1601 D3 Betriebsanleitung

FUSE CHECK/REPLACEMENT/RESET

Fuse check
1. Drive the machine on a level fl oor.
2. Engage the parking brake.
3. Turn the ignition key (64) to "O" and remove it.
4. On the panel (38), check for deactivation of one of the following fuses (
(A) F1 (30 A), dust vacuuming
(B) F2 (16 A), fi lter shaker
(C) F4 (30 A), ignition key
(D) F5 (16 A), engine accessories
(E) F3 (10 A), dust guard system (if equipped)
(F) F6 (10 A), working lights (optional)
(G) F7, light system (optional)
(H) F8, cab blower (optional)
Reset any deactivated fuse, when the component that caused deactivation has fully cooled down.
Fuse check/replacement
1. Drive the machine on a level fl oor.
2. Engage the parking brake.
3. Turn the ignition key (64) to "O" and remove it.
4. Open the engine compartment hood (1) by using the unlocking push-button (25).
5. In the driver's seat area, remove the covers and check the following fuses (Fig. 12 and 13) for integrity:
(I) F9 (50 A), pre-heating glow plug (only for SR 1601 D3)
(J) F10 (50 A), alternator
(K) F11 (1 A), hood inner light (optional)
Replace any open fuse. Install the cover.
6. Close the engine compartment hood (1).
K
SR 1601 D3 - SR 1601 P3
A
C
G
I J
Figure 12
SR 1601 D3 / LPG3 / P3
USER MANUAL
:
Fig. 11)
B E
H D F
Figure 11
J
P100327
33019216(2)2009-05 A
ENGLISH
SR 1601 LPG3
Figure 13
P100326
P100327LPG
31