Fuel; Lpg Engine - Nilfisk SR 1601 D3 Betriebsanleitung

FUEL

CAUTION!
– Always stop the engine before fi lling the fuel tank.
– Do not smoke while fi lling the fuel tank.
– Fill the fuel tank in a well-ventilated area.
– Do not fi ll the fuel tank near sparks or open fl ame.
DIESEL AND PETROL ENGINE (SR 1601 D3 / SR 1601 P3)
(Only for SR 1601 D3): If using the machine when the outside temperature is lower than 32°F (0°C), use diesel fuel for low
temperatures.
(Only for SR 1601 P3): Fill the tank (22) with unleaded fuel for vehicles.
NOTE
If the diesel machine runs out of fuel completely, the fuel system must be bled before the engine can be re-started. To
avoid this situation, fi ll the fuel tank (22) when the fuel gauge (56) indicates 1/4 tank. Fuel tank capacity is 14 USgal (35
litres).

LPG ENGINE

Install an LPG tank (50) having characteristics which comply with the laws in force in the country where it used.
Connect the fuel hose and open the cutoff valve on the tank. Always wear gloves when connecting and disconnecting the fuel hose.
When the machine is not operating, close the LPG tank valve.
NOTE
Place the LPG tank in a proper horizontal position. Connect the fuel hose to the tank and check that there are no gas
leaks.
DANGER!
Do not use the machine in case of gas leaks. Disconnect the fuel hose and replace the LPG tank. If the gas leak
persists, disconnect the fuel hose and contact the Nilfi sk Service Center.
SR 1601 D3 / LPG3 / P3
USER MANUAL
33019216(2)2009-05 A
ENGLISH
17