Scheduled Maintenance Table - Nilfisk SR 1601 D3 Betriebsanleitung

ENGLISH

SCHEDULED MAINTENANCE TABLE

NOTE
Maintenance intervals given are for average operating conditions. Machines used in severe operational environments
may require service more often.
Procedure
Engine coolant check
Engine oil level check
Hydraulic oil level check
Parking brake check
Main and side broom cleaning
Engine oil change
Oil fi lter element replacement
V-belt check
Engine coolant circuit check
Battery check
Dust guard system water fi lter check and cleaning
(optional)
Engine air fi lter cleaning
Engine radiator and oil cooler cleaning
Broom check and adjustment
Hopper dust fi lter check and cleaning ("A" method)
Skirt integrity, height and operation check
Hopper gasket integrity check
Engine maintenance
Steering wheel bearing and hydraulic piston
lubrication
Tank hydraulic oil fi lter replacement
Pump hydraulic oil fi lter replacement
Hopper dust fi lter check and cleaning ("B" method)
Fuel fi lter replacement
Fuel fi tting and screw tightening
Hopper dust fi lter check and cleaning ("C"
method)
Hydraulic oil "recharge" fi lter replacement
Tank hydraulic oil change
(1) For the relevant procedure, see the Service Manual.
(2) Or more often in dusty areas.
(3) Maintenance procedures to be performed by an authorised KUBOTA dealer.
(4) Change the hydraulic oil for the fi rst time after 500 hours, then every year.
22
USER MANUAL
Upon delivery
33019216(2)2009-05 A
After the
Daily fi rst 50
hours
(1)
(1)
(1)
(1)
SR 1601 D3 / LPG3 / P3
Every Every
Every 30
150 300
hours
hours hours
(1)
(1)
(1)
(2)
(2)
(1) - (3)
(1)
(1)
(1)
(2)
(1)
(1)
(2)
Every
1,000
hours
(1)
(1) - (4)